
外保温系统的材料进场时验收出厂质量证明文件,验收结果应经监理工程师检查认可,且应形成相应的验收记录。各种材料和构件的质量证明文件与相关技术资料应齐全,并应符合设计要求和国家现行有关标准的规定。
■外保温局部修复面积合计≥1000㎡时,验收内容如下:
材料进场验收+见证取样送检
当合计的面积满足此要求时,除了对外墙外保温相关材料进行进场验收质量证明文件外,施工单位取样人员应在监理工程师的见证下,按照有关规定现场随机抽样复验,合格后方可使用。
二、外墙外保温系统单元墙体修复
外墙外保温单元墙体修复工程相对于局部修工程来说要求较高,除了材料进场验收和见证取样复检项目外,还增加了完工后的实体检测项目。
■当外保温修复面积合计≤1000㎡且非整个立面墙体修复时,验收内容如下:
进场验收
■当外保温修复面积合计≥1000㎡且非整个立面墙体修复时,验收内容如下:
进场验收+监理见证取样复验+外墙外保温粘贴拉拔试验
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; box-sizing: border-box !important; overflow-wrap: break-word !important;">砖砌墙体维修
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">1.外墙面裂缝渗漏维修
外墙面裂缝渗漏维修前应对墙面的粉刷装饰层进行检查、修补和清理。墙面粉刷装饰层起壳、剥落和酥松等部分应凿除重新修补,墙面修补、清理后应坚实、平整,无浮渣、积垢和油渍。
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">2.墙体变形缝渗漏维修
墙体原采用弹性材料嵌缝的变形缝,应清除缝内已失效的嵌缝材料及浮灰、杂物,缝壁干燥后设置背衬材料,分层嵌填密封材料。密封材料与缝壁应粘牢封严;原采用金属折板盖缝的变形缝,应更换已锈蚀损坏的金属折板,折板应顺水流方向搭接,搭接长度不应小于40mm。金属折板应做好防锈处理后锚固在砖墙上,螺钉眼宜用与金属折板颜色相近的密封材料嵌填、密封。
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">3.分格缝渗漏维修
外粉刷分格缝渗漏维修,应清除缝内的浮灰、杂物,满涂基层处理剂,干燥后,嵌填密封材料。密封材料与缝壁应粘牢封严,表面刮平。
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">4.穿墙管根部渗漏维修
穿墙管道根部渗漏维修,应用C20细石混凝土或1:2水泥砂浆固定穿墙管的位置,穿墙管与外墙面交接处应设置背衬材料,分层嵌填密封材料。
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">5.门窗框与墙体连接处缝隙渗水维修
应沿缝隙凿缝并用密封材料嵌缝,在窗框周围的外墙面上喷涂二遍防水剂。
ntent="t" style="-webkit-tap-highlight-color: transparent; margin: 0px; padding: 0px; outline: 0px; max-width: 100%; clear: both; min-height: 1em; font-family: PingFangSC-Semibold, "PingFang SC"; font-weight: bold; color: rgb(206, 63, 61); line-height: 22px; letter-spacing: 1px; box-sizing: border-box !important; overflow-wrap: break-word !important;">6.阳台、雨篷根部墙体渗漏维修
(2)阳台、雨篷的滴水线损坏,应重做或修补,其深度和宽度均应不小于10mm,并排列整齐。